Inovonics FA113 User Manual download pdf

FA113

Frequency Agile

900MHz

4-Button Command Transmitter

Installation Instructions

02226C

Operation

The FA113

button arms the system.

The FA113

OFF

button disarms the system.

Pressing both “

” buttons simultaneously sends an

emergency alarm signal.

Press and hold the button or buttons to activate.

Activation signals are transmitted multiple times, and are

indicated by the blinking transmission indicator LED.

Fold line indicator:

Cut line indicator:

Important Notes

These products are designed to be installed and

maintained by professional security technicians.

Products, unless specifically noted, are intended for indoor

use.

Manually test all products regularly.

Inovonics Wireless Corporation

315 CTC Blvd

Louisville CO 80027

(800) 782-2709

FAX: (303)939-8977

www.inovonics.com

E-MAIL: [email protected]

02226c.doc LIT-FA113-INSTALL hc:19-Sep-01

Opening the transmitter

Insert a small slotted screwdriver in the slot behind the

transmission indicator LED.

Apply careful leverage, bringing the handle of the

screwdriver forward to pry open the transmitter case.

To close the transmitter housing, snap the case

together, aligning the bottom edge first.

ATTENTION: The battery is not supervised in this

arming device. Test the FA113 weekly.

Programming the FA113 to the Inovonics Vision Plus

1. Program the FA113 type as Remote.

2. Select Monitored, Audible and Relay Out options as desired.

3. Press "Enter" when prompted "ENTER to program".

4. When prompted to "Plug in xmitter", connect the programming

cable from the KP103 executive keypad to the transmitter

programming header and press the transmitter reset button.

5. Disconnect the programming cable.

6. The FA113

button will arm the system in the Away mode.

NOTE: FA113 transmitters retain programming data in non-

volatile memory. They do not require reprogramming after loss

of power. Install a new battery and press the reset button to

re-initialize the transmitter and restore programming.

Device type: Remote

Typical battery life: 3 to 5 years

Battery: 3.0V lithium Sanyo CR2

* To extend battery life, actual check-in interval is 2 to 3 times the programmed value.

Optional Mounting

If desired, the FA113 can be screw-mounted to a fixed surface. Drill

through-holes (.200" max diameter) in the back housing cover in

locations shown below. Wood screws used to mount the transmitter

should be size #8 or smaller. Screw head height must be less than

.150". Larger screw heads may cause short-circuits on the unit.

1 2

Frequency Agile 1
900MHz 1

Summary of Contents

Page 1 - 900MHz

FA113 Frequency Agile® 900MHz 4-Button Command Transmitter Installation Instructions 02226C Operation The FA113 ON button arms the system. The FA1

Page 2

Warranty & Disclaimer Inovonics Wireless Corporation ("Inovonics") warrants its products ("Product" or "Products")

Comments to this Manuals

No comments

Inovonics FA113 User Manual

Browse online or download User Manual for Communication Inovonics FA113. Inovonics FA113 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Communication Inovonics FA113