Inovonics EN4216MR User Manual download pdf (Page 5)

14 ADT Focus 200 Plus / Focus Cadet Control Panel Wiring and Programming Information

14.1 Typical EN4216MR Receiver Connection to ADT Focus 200 Plus / Focus Cadet Control Panel

EN4216MR Function EN4216MR

Terminal

Panel Terminal Keypad Text

Power in (12V DC) Vs (19) + Aux Power n/a

Ground GND (20) - Aux Power n/a

Alarm 1 NC (1) (25) Point 1 (user text)

(Follower) Com 1 (26) Common

NO (1)

Alarm 2 NC (2) (27) Point 2 (user text)

(Follower) Com 2 (28) Common

NO (2)

Repeater AC Loss NC (3) (29) Point 3 RF Repeater AC

(Follower) Com 3 (30) Common

NO (3)

RF Pt Low Battery NC (4) (32) Point 4 RF Pt Low Batt

(Latching) Com 4 (31) Common

NO (4)

RF Pt Tamper NC (5) RF Pt Trouble

(Latching) Com 5 (34) Common

NO (5)* (33) Point 5

RF Pt Inactive NC (6) (35) Point 6 RF Pt Inactive

(Follower) Com 6 (34) Common

NO (6)

Power Loss POWER LOSS (36) Point 7 RF Recvr Power

(Follower) (37) n/a

Receiver Tamper TAMP * n/a n/a

RF Jam JAM (38) Point 8 RF System Jammed

(Follower) (37) n/a

* Point 5 is normally open to allow RF Pt Tamper and Receiver Tamper on one loop.

The end-of-line resistor must not be in series with the wire from terminal NO (5) to terminal 33. Add the following 2 connections to

terminate the combined loop:

1. Connect a wire from TAMP terminal to NO (5) terminal.

2. Connect a 2K-ohm resistor from TAMP terminal to COM 5 terminal.

1 2 3 4 5 6 7 8 9 10

No comments

Inovonics EN4216MR User Manual Page 5