Inovonics EN1223D User Manual download pdf (Page 2)

4/27/12 05583D © Inovonics, 2012 - www.inovonics.com 2

End User Recommendations

IP54 certification is classified as water-resistant, but not waterproof. The

products are not designed for submersion in water. As such, we offer the

following recommendations for end users:

Note: Dust and water ingress protection is not part of the UL listing.

3.3 Battery Replacement

Replacement batteries can be purchased from Inovonics using the

following part numbers

• BAT609 for a single battery

• BAT609-25 for a 25-count bulk pack

To replace the batteries:

1. Remove the three housing screws on the back of the transmitter.

2. Remove the rear cover to expose the side of the board which holds the

battery.

Caution: Carefully separate the rear housing cover, ensuring the reset

button plunger assembly does not fall out of the housing (Figure 2).

3. Remove the depleted battery.

4. Slide the new battery under the battery holder, ensuring that it is fully

inserted and that the positive terminal (+) faces up (Figure 2).

5. Replace the rear housing cover.

6. Replace the three housing screws, tightening them to 1.25 inch-pounds

torque.

7. Once the unit has been sealed, press the reset button located on the

rear housing to complete the configuration (Figure 1).

Note: If you do not have a torque driver, tighten to a snug fit, being careful

not to strip the housing.

Note: Tighten the housing screws evenly to help ensure a good seal and

maintain water-resistance.

Caution: Over-tightening the housing screws can result in microcracks in

the plastic, gaps in the gasket material, and/or stripping of the bushing. Any

of these conditions can compromise the water-resistance of the device.

4 Test the Transmitter

The transmitter should be tested weekly and after registration to ensure

operation.

To test the transmitter:

1. Press both activation buttons simultaneously for at least one second

and ensure the transmit LED lights and the alarm is received by the

receiver or gateway.

2. Press the reset button and ensure the transmit LED lights.

5 Specifications

Dimensions: 5.6 x 4.8 x 1.8 cm (2.2 x 1.9 0.72”)

Operating temperature: 0 to 60°C (32 to 140°F); 0 to 49°C (32 to 120°F) for

UL installations

Operating environment: Water-resistant, non-submersible

Certifications: IP54 Dust and Water Resistance (IEC 60529)

Typical battery life: 1-2 years

Battery type: Renata CR2450, Panasonic CR2450

Power requirement: 3 VDC, 60 mA

UL listings: UL 1023, ULC/ORD-C1023-74

Compatible receiver: EN4216MR, EN4232MR, EN7285

Note: Specifications and data are subject to change without notice.

6 Television and Radio Interference

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

7 FCC Part 15 and Industry Canada Compliance

This device complies with part 15 of the FCC Rules and Industry Canada

license-exempt RSS standard(s). Operation is subject to the following two

conditions: (1) this device may not cause interference, and (2) this device

must accept any interference, including interference that may cause

undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables

aux appareils radio exempts de licence. L'exploitation est autorisée aux

deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage,

et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique

subi, même si le brouillage est susceptible d'en compromettre le

fonctionnement.

8 US Patent Numbers

• 7,154,866

• 7,554,932

• 7,746,804

9 Warranty and Disclaimer

Note: Changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate the

equipment.

Inovonics Wireless Corporation ("Inovonics") warrants its products

("Product" or "Products") to conform to its own specifications and to be free

of defects in materials and workmanship under normal use for a period of

thirty-six (36) months from the date of manufacture. Within the warranty

period, Inovonics will repair or replace, at its option, all or any part of the

warranted Product. Inovonics will not be responsible for dismantling and/or

reinstallation charges. To exercise the warranty, the User ("User", "Installer"

or "Consumer") must work directly through their authorized distributor who

will be given a Return Material Authorization ("RMA") number by Inovonics.

Details of shipment will be arranged directly through the authorized

distributor.

This warranty is void in cases of improper installation, misuse, failure to

follow installation and operating instructions, alteration, accident or

tampering, and repair by anyone other than Inovonics.

This warranty is exclusive and expressly in lieu of all other warranties,

obligations or liabilities, whether written, oral, express, or implied. There is

no warranty by Inovonics that Inovonics product will be merchantable or fit

for any particular purpose, nor is there any other warranty, expressed or

implied, except as such is expressly set forth herein. In no event shall

Inovonics be liable for an incidental, consequential, indirect, special, or

exemplary damages, including but not limited to loss of profit, revenue, or

contract, loss of use, cost of down time, or interruption of business, nor any

claim made by distributor's customers or any other person or entity.

This warranty will not be modified or extended. Inovonics does not

authorize any person to act on its behalf to modify or extend this warranty.

This warranty will apply only to Inovonics Products. Inovonics will not be

liable for any direct, incidental, or consequential damage or loss

whatsoever, caused by the malfunction of Product due to products,

accessories, or attachments of other manufacturers, including batteries,

used in conjunction with Inovonics Products.

Usage Situation OK to Use? Cautions

Shower Yes Do not spray water directly on

the device at distances of less

than 12 inches; avoid spraying

water at high pressure

Bath Yes Do not submerge the device

Rain Yes Avoid extended exposure;

wear the device under a

sleeve, shirt, or jacket

Water Exercise No Do not use the device during

these activities

1 2

Comments to this Manuals

No comments

Inovonics EN1223D User Manual Page 2

Comments to this Manuals

Related products and manuals for Communication Inovonics EN1223D